Extreme Networks EAS 200-24p Switch, Manual

Page: 388 / 908

Chapter 25: IGMP / MLD Snooping Command List
Extreme Networks EAS 200-24p Switch CLI Manual
388
interface if there are no reports received after the response time (which is last member query interval
* robustness variable)
●
<sec 1-25> - Enter the last member query interval value here. This value must be between 1 and
25 seconds.
●
state - (Optional) If the state is enabled, it allows the switch to be selected as an IGMP Querier
(sends IGMP query packets). It the state is disabled, then the switch cannot play the role as a querier.
Note that if the Layer 3 router connected to the switch provide only the IGMP proxy function but
does not provide the multicast routing function, then this state must be configured as disabled.
Otherwise, if the Layer 3 router is not selected as the querier, it will not send the IGMP query packet.
Since it will not send the multicast-routing protocol packet, the port will be timed out as a router
port.
●
enable - Enter enable to enable this state.
●
disable - Enter disable to disable this state.
●
version - (Optional) Specify the version of IGMP packet that will be sent by this port. If an IGMP
packet received by the interface has a version higher than the specified version, this packet will be
dropped.
●
<value 1-3> - Enter the version number here. This value must be between 1 and 3.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the IGMP snooping querier:
EAS 200-24p:admin# config igmp_snooping querier default query_interval 125 state
enable
Command: config igmp_snooping querier default query_interval 125 state enable
Success.
EAS 200-24p:admin#