Extreme Networks EAS 200-24p Switch, Manual

Page: 429 / 908

create mld_snooping static_group
Extreme Networks EAS 200-24p Switch CLI Manual
429
create mld_snooping static_group
Description
This command allows you to create an MLD snooping static group. Member ports can be added to the
static group. The static member and the dynamic member ports form the member ports of a group.
The static group will only take effect when MLD snooping is enabled on the VLAN. For those static
member ports, the device needs to emulate the MLD protocol operation to the querier, and forward the
traffic destined to the multicast group to the member ports.
For a layer 3 device, the device is also responsible to route the packets destined for this specific group to
static member ports.
The static member ports will only affect MLD V2 operation.
The Reserved IP multicast addresses FF0x::/16 must be excluded from the configured group.
The VLAN must be created first before a static group can be created.
Format
create mld_snooping static_group [vlan <vlan_name 32> | vlanid <vlanid_list>]
<ipv6addr>
Parameters
●
vlan - Specify the name of the VLAN on which the static group resides.
●
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters long.
●
vlanid - Specify the ID of the VLAN on which the static group resides.
●
<vlanid_list> - Enter the VLAN ID list here.
●
<ipv6addr> - Specify the multicast group IPv6 address.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create an MLD snooping static group for VLAN 1, group FF1E::1:
EAS 200-24p:admin# create mld_snooping default FF1E::1
Command: create mld_snooping default FF1E::1
Success.
EAS 200-24p:admin#