Extreme Networks EAS 200-24p Switch, Manual

Page: 470 / 908

Chapter 30: Link Layer Discovery Protocol (LLDP) Command List
Extreme Networks EAS 200-24p Switch CLI Manual
470
config lldp
Description
This command is used to change the packet transmission interval.
Format
config lldp [message_tx_interval <sec 5-32768> | message_tx_hold_multiplier
<int 2-10> | tx_delay <sec 1-8192> | reinit_delay <sec 1-10>]
Parameters
●
message_tx_interval - Changes the interval between consecutive transmissions of LLDP
advertisements on any given port. The default setting 30 seconds.
●
<sec 5-32768> - Enter the message transmit interval value here. This value must be between 5 and
32768 seconds.
●
message_tx_hold_multiplier - Specifies to configure the message hold multiplier. The default setting
4.
●
<2-10> - Enter the message transmit hold multiplier value here. This value must be between 2
and 10.
●
tx_delay - Specifies the minimum interval between sending of LLDP messages due to constantly
change of MIB content. The default setting 2 seconds.
●
<sec 1-8192> - Enter the transmit delay value here. This value must be between 1 and 8192
seconds.
●
reinit_delay - Specifies the minimum time of reinitialization delay interval. The default setting 2
seconds.
●
<sec 1-10> - Enter the re-initiate delay value here. This value must be between 1 and 10 seconds.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To change the packet transmission interval:
EAS 200-24p:admin# config lldp message_tx_interval 30
Command: config lldp message_tx_interval 30
Success.
EAS 200-24p:admin#