Extreme Networks EAS 200-24p Switch, Manual

Page: 838 / 908

Chapter 64: Trusted Host Command List
Extreme Networks EAS 200-24p Switch CLI Manual
838
create trusted_host
Description
The create trusted host command creates the trusted host. The switch allows you to specify up to three
IP addresses that are allowed to manage the switch via in-band SNMP or TELNET based management
software. These IP addresses must be members of the Management VLAN. If no IP addresses are
specified, then there is nothing to prevent any IP address from accessing the switch, provided the user
knows the Username and Password.
When the access interface is not specified, the trusted host will be created for all interfaces.
Format
create trusted_host [<ipaddr> |<ipv6addr> | network <network_address> |
ipv6_prefix <ipv6networkaddr>] {snmp | telnet | ssh | http | https | ping}
Parameters
●
<ipaddr> - The IP address of the trusted host.
●
<ipv6addr> - The IPv6 address of the trusted host.
●
network - The network address of the trusted network. The form of network address is
xxx.xxx.xxx.xxx/y.
●
<network_address> - Enter the network address used here.
●
ipv6_prefix – Specifies that IPv6 prefix here.
●
<ipv6networkaddr> - Enter the IPv6 network address here.
●
snmp - (Optional) Specifies trusted host for SNMP.
●
telnet - (Optional) Specifies trusted host for TELENT.
●
ssh - (Optional) Specifies trusted host for SSH
●
http - (Optional) Specifies trusted host for HTTP
●
https - (Optional) Specifies trusted host for HTTPs.
●
ping - (Optional) Specifies trusted host for PING
Restrictions
Only Administrator and Operator-level users can issue this command.