Extreme Networks EAS 200-24p Switch, Manual

Page: 178 / 908

Chapter 7: Access Control List (ACL) Egress Command List
Extreme Networks EAS 200-24p Switch CLI Manual
178
●
<vlanid 1-4094> - Enter the VLAN ID used for this configuration here. This value must be
between 1 and 4094.
●
source_mac - (Optional) Specifies the source MAC address.
●
<macaddr> - Enter the source MAC address used here.
●
mask - Specifies that source MAC mask used.
- <macmask> - Enter the source MAC mask value here.
●
destination_mac - Specifies the destination MAC address.
●
<macaddr> - Enter the destination MAC address used here.
●
mask - Specifies that destination MAC mask used.
- <macmask> - Enter the destination MAC mask value here.
●
802.1p - (Optional) Specifies the value of the 802.1p priority tag. The priority tag ranges from 1 to 7.
●
<value 0-7> - Enter the 802.1p priority tag used here.
●
ethernet_type - (Optional) Specifies the Ethernet type.
●
<hex 0x0-0xffff> - Enter the Ethernet type mask used here.
●
ip - Specifies an IP egress ACL rule.
●
vlan - (Optional) Specifies the VLAN name.
●
<vlan_name 32> - Enter the VLAN name used for this configuration here. This name can be up
to 32 characters long.
●
vlanid - Specifies a VLAN ID.
●
<vlanid 1-4094> - Enter the VLAN ID used for this configuration here. This value must be
between 1 and 4094.
●
mask - (Optional) Specifies the mask used.
●
<hex 0x0-x0fff> - Enter the mask value used here.
●
source_ip - (Optional) Specifies an IP source address.
●
<ipaddr> - Enter the source IP address used here.
●
mask - Specifies the source IP address used here.
- <netmask> - Enter the source network mask here.
●
destination_ip - (Optional) Specifies an IP destination address.
●
<ipaddr> - Enter the destination IP address used here.
●
mask - Specifies the destination IP address used here.
- <netmask> - Enter the destination network mask here.
●
dscp - (Optional) Specifies the value of DSCP. The DSCP value ranges from 0 to 63.
●
<value 0-63> - Enter the DSCP value used here. This value must be between 0 and 63.
●
icmp - (Optional) Specifies that the following parameters configured will apply to the ICMP
configuration.
●
type - Specifies that the rule will apply to the ICMP type traffic value.
- <value 0-255> - Enter the ICMP traffic type value here. This value must be between 0 and 255.
●
code - Specifies that the rule will apply to the ICMP code traffic value.
- <value 0-255> - Enter the ICMP code traffic value here. This value must be between 0 and 255.
●
igmp - (Optional) Specifies that the following parameters configured will apply to the IGMP
configuration.
●
type - Specifies that the rule will apply to the IGMP type traffic value.