Dell PowerEdge T610, Hardware Owner'S Manual

Page: 51 / 206

About Your System
51
Unable to launch
System Services
image. System
halted!
System halted after F10
keystroke because System
Services image is either
corrupted in the system
firmware or has been lost due
to system board replacement.
The iDRAC6 Enterprise card
flash memory may be
corrupted.
Restart the system and
update the Unified Server
Configurator repository to
the latest software to restore
full functionality. See the
Unified Server
Configuration user
documentation for more
information.
Restore the flash memory
using the latest version on
support.dell.com. See the
iDRAC6 user's guide for
instructions on performing a
field replacement of the
flash memory.
Unexpected
interrupt in
protected mode
Improperly seated memory
modules or faulty keyboard/
mouse controller chip. Reseat the memory modules.
See "Troubleshooting
System Memory." If the
problem persists, see
"Getting Help."
Unsupported CPU
combination
Unsupported CPU
stepping
detected
Processor(s) is not supported
by the system. Install a supported processor
or processor combination.
See "Processors."
Unsupported DIMM
detected. The
following DIMM
has been
disabled: x
Invalid memory
configuration. The system
will run but with the
specified memory module
disabled. Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines."
Table 1-2. System Messages (continued)
Message Causes Corrective Actions
book.book Page 51 Tuesday, September 15, 2009 10:08 AM