100
Installing System Components
4
Remove the cooling shroud. See "Removing the Cooling Shroud."
5
Disconnect the internal USB module cable from the connector on the
system board, and unroute the cable from the cable guides in the chassis.
See Figure 3-12.
6
Pull up on the module release tab, and slide the internal USB module to
remove it from the slots in the chassis. See Figure 3-12.
7
Install the cooling shroud. See "Installing the Cooling Shroud."
8
Install the expansion card stabilizer. See "Installing the Expansion Card
Stabilizer."
9
Close the system. See "Closing the System."
10
Place the system upright and on its feet on a flat, stable surface.
11
Reattach any peripherals, then connect the system to the electrical outlet.
12
Turn on the system and attached peripherals.
book.book Page 100 Tuesday, September 15, 2009 10:08 AM
Summary of Contents for PowerEdge T610
