Dell PowerEdge T610, Hardware Owner'S Manual

Page: 52 / 206

52
About Your System
Unsupported
memory
configuration.
DIMM mismatch
across slots
detected:
x , x , ...
Invalid memory
configuration. Memory
modules are mismatched in
the specified slots. Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines."
Unused memory
detected. DIMM’s
installed in the
following slot
are not available
when in mirror or
128-bit advanced
ECC modes:
x
,
x
,
x
The memory configuration is
not optimal for mirroring or
Advanced ECC Memory
Mode. Modules in the
specified slots are unused. Reconfigure the memory for
Memory Mirroring or
Advanced ECC Memory
Mode, or change the
memory mode to
Optimized
in the BIOS setup screen.
See "System Memory."
Warning: A fatal
error has caused
system reset!
Please check the
system event log!
A fatal system error occurred
and caused the system to
reboot. Check the SEL for
information that was logged
during the error. See the
applicable troubleshooting
section in "Troubleshooting
Your System" for any faulty
components specified in the
SEL.
Warning: Control
Panel is not
installed.
The control panel is not
installed or has a faulty cable
connection. Install the control panel, or
check the cable connections
between the display module,
the control panel board, and
the system board. See
"Control Panel Assembly."
Warning! No micro
code update
loaded for
processor
n
Micro code update failed. Update the BIOS firmware.
See "Getting Help."
Table 1-2. System Messages (continued)
Message Causes Corrective Actions
book.book Page 52 Tuesday, September 15, 2009 10:08 AM