Dell PowerEdge T610, Hardware Owner'S Manual

Page: 47 / 206

About Your System
47
PCIe Training
Error: Expected
Link Width is x ,
Actual Link Width
is y .
Faulty or improperly installed
PCIe card in the specified
slot. Reseat the PCIe card in the
specified slot number. See
"Troubleshooting Expansion
Cards." If the problem
persists, see "Getting Help."
Plug & Play
Configuration
Error
Error encountered in
initializing PCIe device;
faulty system board. Install the NVRAM_CLR
jumper in the clear position
(pins 1 and 3) and reboot the
system. See Figure 6-1 for
jumper location. If the
problem persists, see
"Troubleshooting Expansion
Cards."
Quad rank DIMM
detected after
single rank or
dual rank DIMM in
socket.
Invalid memory
configuration. Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines."
Read fault
Requested sector
not found
The operating system cannot
read from the hard drive,
optical drive, or USB device,
the system could not find a
particular sector on the disk,
or the requested sector is
defective. Replace the optical medium,
USB medium, or USB
device. Ensure that the USB
cables, SAS/SATA backplane
cables, or optical drive cables
are properly connected. See
"Troubleshooting a USB
Device", "Troubleshooting
an Optical Drive", or
"Troubleshooting a Hard
Drive" for the appropriate
drive(s) installed in your
system.
SATA Port x
device not found
There is no device connected
to the specified SATA port. Information only.
Table 1-2. System Messages (continued)
Message Causes Corrective Actions
book.book Page 47 Tuesday, September 15, 2009 10:08 AM