Danfoss VLT AutomationDrive FC 361, Programming Manual

Page: 33 / 196

0-38 Display Text 2
Range: Function:
•
Parameter 0-20 Display Line
1.1 Small
,
•
Parameter 0-21 Display Line
1.2 Small
,
•
Parameter 0-22 Display Line
1.3 Small
,
•
Parameter 0-23 Display Line
2 Large
, or
•
Parameter 0-24 Display Line
3 Large
.
0-39 Display Text 3
Range: Function:
0
*
[0 - 25] Enter a text which can be viewed in
the graphical display by selecting
[39] Display Text 3 in
•
Parameter 0-20 Display Line
1.1 Small
,
•
Parameter 0-21 Display Line
1.2 Small
,
•
Parameter 0-22 Display Line
1.3 Small
,
•
Parameter 0-23 Display Line
2 Large
, or
•
Parameter 0-24 Display Line
3 Large
.
4.1.5 0-4* LCP Keypad
Enable, disable, and password protect individual keys on
the LCP.
0-40 [Hand on] Key on LCP
Option: Function:
[0] Disabled No effect when [Hand On] is
pressed. Select
[0] Disabled to avoid
accidental start of the frequency
converter in hand-on mode.
[1]
*
Enabled The LCP switches to hand-on mode
directly when [Hand On] is pressed.
0-41 [Off] Key on LCP
Option: Function:
[0] Disabled Avoids accidental stop of the
frequency converter.
[1]
*
Enabled
0-42 [Auto on] Key on LCP
Option: Function:
[0] Disabled Avoids accidental start of the
frequency converter in auto-on
mode.
[1]
*
Enabled
0-43 [Reset] Key on LCP
Option: Function:
[0] Disabled No effect when [Reset] is pressed.
Avoids accidental alarm reset.
[1]
*
Enabled
4.1.6 0-5* Copy/Save
Copy parameters from and to the LCP. Use these
parameters for saving and copying set-ups from 1
frequency converter to another.
0-50 LCP Copy
Option: Function:
NOTICE
This parameter cannot be
adjusted while the motor is
running.
[0]
*
No copy
[1] All to LCP Copies all parameters in all set-ups
from the frequency converter
memory to the LCP memory.
[2] All from LCP Copies all parameters in all set-ups
from the LCP memory to the
frequency converter memory.
[3] Size indep.
from LCP Copy only the parameters that are
independent of the motor size. The
latter selection can be used to
program several frequency
converters with the same function
without disturbing motor data.
[10] Delete LCP
copy data Use to delete the copy after the
transfer is complete.
Parameter Descriptions Programming Guide
MG06J202 Danfoss A/S © 03/2019 All rights reserved. 31
4 4