Danfoss VLT AutomationDrive FC 361, Programming Manual

Page: 108 / 196

9-16 PCD Read Configuration
Array [10]
Option: Function:
[1660] Digital Input
[1661] Terminal 53
Switch Setting
[1662] Analog Input
53
[1663] Terminal 54
Switch Setting
[1664] Analog Input
54
[1665] Analog Output
42 [mA]
[1666] Digital Output
[bin]
[1667] Freq. Input
#29 [Hz]
[1668] Freq. Input
#33 [Hz]
[1669] Pulse Output
#27 [Hz]
[1670] Pulse Output
#29 [Hz]
[1671] Relay Output
[bin]
[1672] Counter A
[1673] Counter B
[1675] Analog In
X30/11
[1676] Analog In
X30/12
[1677] Analog Out
X30/8 [mA]
[1684] Comm. Option
STW
[1687] Bus Readout
Alarm/Warning
[1690] Alarm Word
[1691] Alarm Word 2
[1692] Warning Word
[1693] Warning Word
2
[1694] Ext. Status
Word
[1695] Ext. Status
Word 2
[1697] Alarm Word 3
[1698] Warning Word
3
9-18 Node Address
Range: Function:
126
*
[ 1 - 126 ] Enter the address in this parameter
or in the hardware switch. In order
to adjust the station address in this
parameter, the hardware switch
must be set to 126 or 127.
Otherwise this parameter shows the
actual setting of the switch.
9-19 Drive Unit System Number
Range: Function:
1034
*
[0 - 65535 ] Manufacturer specific system ID.
9-22 Telegram Selection
Option: Function:
This parameter shows the selected
standard PROFIBUS telegram that
the PROFINET IO controller has sent
to the frequency converter. At
power-up, or if a non-supported
telegram is sent from the IO
controller, this parameter shows
None in the display.
[1] Standard
telegram 1
[100]
*
None
[101] PPO 1
[102] PPO 2
[103] PPO 3
[104] PPO 4
[105] PPO 5
[106] PPO 6
[107] PPO 7
[108] PPO 8
Parameter Descriptions VLT® AutomationDrive FC 361
106 Danfoss A/S © 03/2019 All rights reserved. MG06J202
4 4