16-86 FC Port REF 1
Range:
Function:
0
*
[-200 - 200 ]
View the 2-byte status word (STW)
sent to the fieldbus master.
Interpretation of the status word
depends on the fieldbus option
installed and the control word
profile selected in
parameter 8-10 Control Profile
.
16-87 Bus Readout Alarm/Warning
Range:
Function:
0
*
[0 - 65535]
Alarm and warning numbers in hex
as shown in the alarm log. The high
byte contains the alarm, the low
byte contains the warning. The
alarm number is the 1
st
one that
occurred after the last reset.
4.15.7 16-9* Diagnosis Readouts
NOTICE
When using MCT 10 Set-up Software, the readout
parameters can only be read online, that is as the actual
status. This means that the status is not stored in the
MCT 10 Set-up Software file.
16-90 Alarm Word
Range:
Function:
0
*
[0 -
4294967295 ]
Show the alarm word sent via the
serial communication port in hex
code.
16-91 Alarm Word 2
Range:
Function:
0
*
[0 -
4294967295]
View the alarm word sent via the
serial communication port in hex
code.
16-92 Warning Word
Range:
Function:
0
*
[0 -
4294967295 ]
Show the warning word sent via
the serial communication port in
hex code.
16-93 Warning Word 2
Range:
Function:
0
*
[0 -
4294967295]
View the warning word sent via the
serial communication port in hex
code.
16-94 Ext. Status Word
Range:
Function:
0
*
[0 -
4294967295]
Returns the extended warning word
sent via the serial communication
port in hex code.
16-95 Ext. Status Word 2
Range:
Function:
0
*
[0 -
4294967295 ]
Returns the extended status word 2
sent via the serial communication
port in hex code.
16-97 Alarm Word 3
Range:
Function:
0
*
[0 -
4294967295 ]
Show the alarm word 3 sent via the
serial communication port in hex
code.
16-98 Warning Word 3
Range:
Function:
0
*
[0 -
4294967295 ]
View the warning word sent via the
serial communication port in hex
code.
4.16 Parameters: 17-** Feedback
More parameters to configure the feedback from the
encoder (VLT
®
Encoder Input MCB 102), resolver (VLT
®
Resolver Input MCB 103), or the frequency converter itself.
4.16.1 17-1* Inc. Enc. Interface
Parameters in this group configure the incremental
interface of the VLT
®
Encoder Input MCB 102. Both the
incremental and absolute interfaces are active at the same
time.
NOTICE
These parameters cannot be adjusted while the motor is
running.
17-10 Signal Type
Select the incremental type (A/B channel) of the encoder in use.
Find the information on the encoder datasheet.
Select
[0] None
if the feedback sensor is an absolute encoder
only.
Option:
Function:
[0]
None
[1]
*
RS422 (5V
TTL)
[2]
Sinusoidal
1Vpp
Parameter Descriptions
Programming Guide
MG06J202
Danfoss A/S © 03/2019 All rights reserved.
149
4
4
Summary of Contents for VLT AutomationDrive FC 361
Page 2: ......
