Club Car 2005 precendent, Maintenance And Service

Page: 62 / 256

WHEEL BRAKE ASSEMBLIES Brake Cable Removal and Installation
Page 6-12 2005 Precedent Gasoline Golf Car Maintenance and Service Manual
6
Brake Cable Installation
NOTE: The driver-side and passenger-side brake cables are not interchangeable. Make sure the correct
cable is used on the correct side.
1. Insert the end of the new brake cable through the hole in the frame (Figure 6-19, Page 6-11) . Push on
the cable housing so the clips on the housing ends secure the housing in the hole.
2. Hold the bolt (5) and the equalizer bracket (4) in the upright position and slip the cable head through the
hole on top of the bracket. Pivot the equalizer to the horizontal position to capture the cable heads in the
equalizer.
3. Insert the rear cable housing into the shock mount bracket (4) (Figure 6-20, Page 6-11) . Push the cable
housing end into the bracket to ensure the clips on the housing end secure the cable in position.
4. At the rear wheel brake, connect the cable to the brake actuator arm using new clevis pin (2) and new
bow tie locking pin (1) (Figure 6-20, Page 6-11) .
5. Place tab (3) on cable housing over the forward leaf spring mounting bolt (2) (Figure 6-21, Page 6-11) .
Install nut (1). Tighten nut to 18.4 ft-lb (25 N·m).
6. Adjust the brakes. See Brake Cable Equalizer Adjustment on page 6-8.