Club Car 2005 precendent, Maintenance And Service

Page: 150 / 256

ELECTRICAL COMPONENTS GCOR
Page 12-16 2005 Precedent Gasoline Golf Car Maintenance and Service Manual
12
GCOR Installation
1. Position the GCOR on the pedal group.
2. Secure the GCOR with two screws (1) (Figure 12-17, Page 12-16) . Tighten screws to 23 in-lb (2.6 N·m).
3. Install pedal group. See Pedal Group Installation, Section 5, Page 5-6.
Accelerator Pedal Limit Switch
See General Warnings, Section 1, Page 1-1.
Testing the Accelerator Pedal Limit Switch
See Test Procedure 5A, Section 11, Page 11-17.
The accelerator pedal limit switch is housed inside the GCOR. The GCOR is mounted on the pedal group,
and cannot be repaired, but can be replaced.
Kill Limit Switch
See General Warnings, Section 1, Page 1-1.
Testing the Kill Limit Switch
See Test Procedure 5B, Section 11, Page 11-18.
The kill limit switch is housed inside the GCOR. The GCOR is mounted on the pedal group, and cannot be
repaired, but can be replaced.
Neutral Lockout Limit Switch
See General Warnings, Section 1, Page 1-1.
Testing the Neutral Lockout Limit Switch
See Test Procedure 7, Section 11, Page 11-20.
Neutral Lockout Limit Switch Removal
1. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warnings, Section 1, Page 1-2.
2. Disconnect the wires from the neutral lockout limit switch (5) located on the back of the Forward/Reverse
shifter assembly (Figure 12-18, Page 12-17) .
3. Remove two nuts (2) and washers (6) from the neutral lockout limit switch (5) and slide the neutral lock-
out limit switch off of the screws.
Figure 12-17 GCOR
1
GCOR
BAR
GCOR