Club Car 2005 precendent, Maintenance And Service

Page: 173 / 256

FE290 ENGINE Ignition Coil and Flywheel
2005 Precedent Gasoline Golf Car Maintenance and Service Manual Page 13-7
13
IGNITION COIL AND FLYWHEEL
See General Warnings, Section 1, Page 1-1.
Ignition Coil and Flywheel Removal
1. Loosen three screws and remove the remaining four screws attaching the flywheel housing as shown,
then remove the housing (Figure 13-8, Page 13-8).
2. Disconnect the ignition coil (1) from its primary lead wire at the connector (2). Remove the two bolts (3)
and take out the ignition coil (Figure 13-9, Page 13-8) .
3. Hold the flywheel (4), not the fan (7), with a strap wrench (5) and, using a 25 mm socket, remove the fly-
wheel nut (and flat washer) by turning it counterclockwise (Figure 13-10, Page 13-8) . See following
CAUTION.
CAUTION
• The flywheel nut has right-hand threads. Turn it clockwise to tighten, or counterclockwise to
loosen.
• Do not damage the fan blades with the strap wrench. Do not place screwdriver or pry bar in
the fan blades.
4. Remove the flywheel with a puller (CCI P/N 1016627).
5. Remove the flywheel key from its groove.
Figure 13-6 Crankcase Cover Installation Figure 13-7 Fan and Flywheel Assembly
3
5
8
1
6
4
2
7
1
3
M
F
34
81