Club Car 2005 precendent, Maintenance And Service

Page: 154 / 256

ELECTRICAL COMPONENTS Low Oil Warning Light
Page 12-20 2005 Precedent Gasoline Golf Car Maintenance and Service Manual
12
Reverse Buzzer Limit Switch Removal, Continued:
2. Disconnect the wires from the reverse buzzer limit switch (4) located on the back of the Forward/Reverse
assembly (Figure 12-18, Page 12-17) .
3. Remove the nuts (2) and washers (6) from the neutral lockout limit switch (5) and slide the neutral lockout
limit switch off of the screws. Do not disconnect the wires.
4. Remove the spacers (9) from the reverse buzzer limit switch (4) and slide the reverse buzzer limit switch
off the screws.
Reverse Buzzer Limit Switch Installation
1. Install the reverse buzzer limit switch (4), and then install two spacers (9) against the limit switch
(Figure 12-18, Page 12-17) .
2. Install the neutral lockout limit switch (5) with two washers (6) and two nuts (2). Tighten to 5 in-lb
(0.6 N·m). See following CAUTION.
CAUTION
• Do not overtighten the retaining nuts. If the nuts are over tightened, limit switches could be
damaged.
3. Place the Forward/Reverse handle in REVERSE and make sure that both switches actuate.
4. Connect the orange wire to the common (COM) terminal and the red/white wire to the normally open
(NO) terminal of the reverse buzzer limit switch (4) (Figure 12-18, Page 12-17) .
5. Connect battery cables, positive (+) cable first, and tighten hardware to 12 ft-lb (16.3 N·m).
See Figure 1-1, Section 1, Page 1-3. Coat terminals with Battery Terminal Protector Spray (CCI P/N
1014305) to minimize corrosion.
6. Shift the Forward/Reverse handle to the REVERSE position. The buzzer should sound.
LOW OIL WARNING LIGHT
See General Warnings, Section 1, Page 1-1.
Testing the Low Oil Warning Light
See Test Procedure 22, Section 11, Page 11-33.
Low Oil Warning Light Removal
1. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warnings, Section 1, Page 1-2.
2. Remove the instrument panel. See Key Switch Removal on page 12-13.
3. Disconnect the wires from the low oil warning light (11) (Figure 12-21, Page 12-21) .
4. Press the retaining tabs and remove the low oil warning light from the instrument panel.