Club Car 2005 precendent, Maintenance And Service

Page: 29 / 256

BODY AND TRIM Kick Plate and Choke Button
2005 Precedent Gasoline Golf Car Maintenance and Service Manual Page 4-7
4
FLOOR MAT RETAINER REMOVAL
1. Remove screws (2) from top of retainer (1) (Figure 4-4, Page 4-6) .
2. Remove screw (4) from lower rear corner of retainer. This screw threads into a J-clip (5) that is attached
to the rear underbody.
3. Carefully pull on retainer to separate the trim clips from their respective slots. Trim clips do not normally
need to be removed from the retainer.
FLOOR MAT RETAINER INSTALLATION
1. Position the retainer on the vehicle and press firmly to engage the trim clips to the vehicle (Figure 4-4,
Page 4-6) .
2. Install one screw (4) at the lower rear of the retainer. Tighten screw to 1.8 ft-lb (2.5 N·m).
3. Ensure the floor mat is properly positioned beneath the top flange of the retainer and install two screws
(2). Tighten screws to 4.4 ft-lb (6.0 N·m).
KICK PLATE AND CHOKE BUTTON
See General Warnings, Section 1, Page 1-1.
KICK PLATE AND CHOKE BUTTON REMOVAL
1. Access the inside of the fuel bucket and disconnect hair spring cotter pin (2) from choke rod (3). Remove
rod from the choke (Figure 4-5, Page 4-8) .
2. Remove floor mat. See Floor Mat and Retainers on page 4-6.
3. Remove three screws (1) that hold the kick plate (4) to the vehicle.
4. Remove the two front screws (7) that hold the beauty panel to the vehicle. Raise the forward portion of
the rear beauty panel to disengage it from the tabs on the upper portion of the kick plate.
5. Remove kick plate from vehicle.
6. Disengage the choke rod (3) from the button (5).
7. Press in on the tabs on the top and bottom of button (5) to free the button from the kick plate. Remove
button (5) and spring (6).
KICK PLATE AND CHOKE BUTTON INSTALLATION
1. Place spring (6) in kick plate (4) and orient the tabs on the button (5) with the slots in the kick plate. Press
in the button until it snaps in place in the kick plate (Figure 4-5, Page 4-8) .
2. Insert the tabbed end of the choke rod (3) into the rear slot on the button (5).
3. Position the kick plate (4) on the vehicle and secure with three screws (1). Ensure front lower edge of rear
beauty panel mates with the kick plate. Tighten screws to 3.3 ft-lb (4.5 N·m).
4. Insert choke rod (3) through the choke actuator. Secure the rod with hair spring cotter pin (2),
5. Install two front screws to secure the rear beauty panel. Tighten screws to 3.7 ft-lb (5 N·m).
6. Install floor mat. See Floor Mat and Retainers on page 4-6.