Club Car 2005 precendent, Maintenance And Service

Page: 146 / 256

ELECTRICAL COMPONENTS Voltage Regulator
Page 12-12 2005 Precedent Gasoline Golf Car Maintenance and Service Manual
12
VOLTAGE REGULATOR
See General Warnings, Section 1, Page 1-1.
Testing the Voltage Regulator
See Test Procedure 11, Section 11, Page 11-23.
Voltage Regulator Removal
1. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warnings, Section 1, Page 1-2.
2. Disconnect the voltage regulator connector (3) from the wire harness (Figure 12-15, Page 12-12) .
3. Remove the voltage regulator mounting screw (2) and remove the voltage regulator (1).
Voltage Regulator Installation
1. Position the voltage regulator (1) and install the mounting screw (2) (Figure 12-15, Page 12-12) . Tighten
screw to 23 in-lb (2.6 N·m).
2. Connect the voltage regulator three-pin connector (3) to the wire harness.
3. Connect battery cables, positive (+) cable first, and tighten hardware to 12 ft-lb (16.3 N·m).
See Figure 1-1, Section 1, Page 1-3. Coat terminals with Battery Terminal Protector Spray (CCI P/N
1014305) to minimize corrosion.
4. Place Forward/Reverse handle in NEUTRAL and place the neutral lockout cam in the MAINTENANCE
position. Start the engine and check regulator for proper functioning as described in the voltage regulator
test procedure.
See Test Procedure 11, Section 11, Page 11-23.
Figure 12-15 Voltage Regulator
2
1
3