Club Car 2005 precendent, Maintenance And Service

Page: 149 / 256

ELECTRICAL COMPONENTS Fuse
2005 Precedent Gasoline Golf Car Maintenance and Service Manual Page 12-15
12
FUSE
See General Warnings, Section 1, Page 1-1.
Testing the Fuse
See Test Procedure 2, Section 11, Page 11-15.
Fuse Removal
1. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warnings, Section 1, Page 1-2.
2. Remove cover from fuse holder.
3. Remove the fuse from the fuse holder.
Fuse Installation
1. Install the fuse. See following WARNING.
ý
WARNING
• If a fuse is blown, determine the cause of the failure and make necessary repairs before
installing a new fuse. Use the appropriately rated fuse; if a fuse with a higher amp rating is
used, damage to the vehicle electrical system may occur.
2. Install the cover on the fuse holder.
3. Connect battery cables, positive (+) cable first, and tighten hardware to 12 ft-lb (16.3 N·m).
See Figure 1-1, Section 1, Page 1-3. Coat terminals with Battery Terminal Protector Spray (CCI P/N
1014305) to minimize corrosion.
GCOR
See General Warnings, Section 1, Page 1-1.
The GCOR is mounted on the passenger side of the pedal group. The GCOR houses two limit switches; the
kill limit switch and the accelerator pedal limit switch. The two switches are actuated by motion of the GO
pedal and are instrumental in safe vehicle operation.
GCOR Removal
1. Remove the pedal group. See Pedal Group Removal, Section 5, Page 5-1.
2. Remove two screws (1) that secure the GCOR to the pedal group (Figure 12-17, Page 12-16) .