Club Car 2005 precendent, Maintenance And Service

Page: 45 / 256

ACCELERATOR AND BRAKE PEDAL GROUP Pedal Group
2005 Precedent Gasoline Golf Car Maintenance and Service Manual Page 5-3
5
Pedal Group Removal, Continued:
7. Loosen turnbuckle (6) until the threaded rod from the pedal group is free of the turnbuckle.
8. Loosen two nuts (8 and 9) on the accelerator cable and lift the cable from its mounting bracket.
9. Remove two screws (2) on the driver side of the pedal group and two screws (1) on the passenger side
of the pedal group.
10. Slightly lift pedal group from the vehicle to gain access to the connections (11 and 12) to the GCOR on
the passenger side of the pedal group.
11. Disconnect the electrical connector at the GCOR.
12. Release the end of the accelerator cable (10) from the pedal group.
13. Remove two screws (1) to separate the GCOR from the pedal group (Figure 5-3, Page 5-3) .
GCOR
The pedal group for the Precedent gasoline vehicle includes a Gasoline Controller Output Regulator (GCOR)
mounted on the side of the pedal group. The GCOR houses two limit switches; the kill limit switch and the
accelerator pedal limit switch. The two switches are actuated by motion of the GO pedal.
DEBRIS SHIELDS
Debris shields on the top face of the pedal group prevent excessive debris from contacting the moving parts
of the pedal group. Both shields (3 and 4) are held in place with screws (1) and washers (2)
(Figure 5-4,
Page 5-5) . When shields are replaced, tighten screws (1) to 53 in-lb (6 N·m).
BRAKE RETURN SPRING
ý
CAUTION
• Spring is under tension. Use caution when working with springs.
The brake return spring (5) provides the pressure needed to return the brake pedal to its upright position
(Figure 5-4, Page 5-5) . One end of the spring attaches to a hook on pedal (11) and the other end attaches to
pedal base (12).
Figure 5-3 GCOR Removal
1
GCOR
BAR
GCOR