Club Car 2005 precendent, Maintenance And Service

Page: 235 / 256

TORQUE CONVERTER Drive Clutch
2005 Precedent Gasoline Golf Car Maintenance and Service Manual Page 17-9
17
6. Remove the retaining ring (3) from the shaft of the fixed face assembly (7) and slide the moveable face
(14) off the shaft (Figure 17-7, Page 17-6) . See following NOTE.
NOTE: If the moveable face is removed from the hub of the fixed face, the spiral back-up rings (12) must
be replaced with new ones
(Figure 17-7, Page 17-6) .
7. Remove the spacer (16), spring (4), and retainer (5). The spring retainer can be removed from the spring
if necessary (Figure 17-7, Page 17-6) .
8. If necessary, remove idler bearing. Use a press to remove the bearing (Figure 17-14, Page 17-9) . See
following NOTE.
NOTE: Do not remove the idler bearing unless it needs to be replaced. If idler bearing is removed, replace
it with a new bearing.
9. Use a scribe or small pick to remove the spiral backup rings (12) from each end of the bore in the fixed
face assembly (Figure 17-7, Page 17-6) . See also Figure 17-15, Page 17-9 . Discard the rings.
Figure 17-12 Install Pin and Washer Figure 17-13 Install Secondary Weight
Figure 17-14 Remove Idler Bearing Figure 17-15 Spiral Back-up Rings
PRIMARY
WEIGHT
PIN
WAVE
WASHER
SMALL PIN
SECONDARY
WEIGHT
PIN
PRESS RAM
IDLER BEARING
BEARING PULLER
FIXED FACE
ASSEMBLY