Club Car 2005 precendent, Maintenance And Service

Page: 217 / 256

UNITIZED TRANSAXLE Unitized Transaxle Installation
2005 Precedent Gasoline Golf Car Maintenance and Service Manual Page 16-15
16
UNITIZED TRANSAXLE INSTALLATION
See General Warnings, Section 1, Page 1-1.
1. Install the wheels. See Wheel Installation, Section 8, Page 8-1.
2. Two-passenger vehicles: Install the leaf springs. See Leaf Spring Installation (Two-Passenger Vehi-
cles), Section 9, Page 9-4.
3. Four-passenger vehicles: Install the leaf springs. See Leaf Spring Installation (Four-Passenger
Vehicles), Section 9, Page 9-6.
4. Position the transaxle mounting plate on the two mounting studs at the rear of the engine, and then install
the two mounting nuts finger tight (Figure 16-36, Page 16-16) .
5. Install the remaining four mounting bolts, four flat washers, and four nuts (one bolt and nut at each corner
of the mounting plate) finger tight.
6. Tighten the four corner nuts (with bolts) to 23 ft-lb (31.2 N·m). Tighten the two center nuts (on the engine
block studs) to 17 ft-lb (23.1 N·m) (Figure 16-36, Page 16-16) .
7. Install the accelerator cable bracket on transaxle case. Tighten the mounting screws to 134 in-lb
(15.1 N·m) (Figure 16-37, Page 16-16) .
Figure 16-34 Transaxle Mounting
Club
Car
ClubC
ar
WOODEN
BLOCKS
TRANSAXLE
MOUNTING NUT
TRANSAXLE MOUNTING
BOLT AND NUT
(TYPICAL 4 PLACES)
(TYPICAL 2 PLACES)