Club Car 2005 precendent, Maintenance And Service

Page: 211 / 256

UNITIZED TRANSAXLE Unitized Transaxle Removal
2005 Precedent Gasoline Golf Car Maintenance and Service Manual Page 16-9
16
4.7. Use a screwdriver or flat blade to snap the shifter cable rod end from the shifter arm on the unitized
transaxle. Compress the retaining clips on the cable boot and push the cable through the shifter
bracket
(Figure 16-15, Page 16-9) .
4.8. Mark for identification and then disconnect the 6-gauge white wire (F2 post), 6-gauge black ground
wire (A2 post), and 16-gauge yellow wire (DF post) from starter/generator (Figure 16-16,
Page 16-9) .
4.9. Disconnect the engine oil level sensor wire (18-gauge yellow) at the connector just to the rear of the
starter/generator) (Figure 16-17, Page 16-10) .
4.10. Disconnect the engine kill switch wire (18-gauge white/black) from the bullet connector at the lower
right front of the engine (Figure 16-18, Page 16-10) .
Figure 16-13 Throttle Cable Mounting Figure 16-14 Engine Ground Wire
Figure 16-15 Shifter Cable Figure 16-16 Generator Wires
1
ACCELERATOR
CABLE
1
ENGINE GROUND
RETAINING NUT
CABLE
BOOT
SHIFTER
ARM
CLIP
F2
DF
YELLOW
WIRE
WHITE
WIRE
GROUND
WIRE