Club Car 2005 precendent, Maintenance And Service

Page: 219 / 256

UNITIZED TRANSAXLE Unitized Transaxle Installation
2005 Precedent Gasoline Golf Car Maintenance and Service Manual Page 16-17
16
Unitized Transaxle Installation, Continued:
8. Install the governor cable bracket on transaxle case. Tighten the mounting screws to 134 in-lb (15.1 N·m)
(Figure 16-38, Page 16-17) .
9. Install governor lever arm on governor shaft (Figure 16-39, Page 16-17) .
9.1. With the governor lever arm loose on the governor shaft, turn the governor arm shaft counterclock-
wise until it stops. Then pull the governor lever arm rearward until the carburetor throttle is in the
“wide open throttle” (WOT) position
(Figure 16-39, Page 16-17) .
9.2. While holding the arm and shaft in the fully counterclockwise position, tighten the governor arm
lever nut to 35 in-lb (4.0 N·m) (Figure 16-39, Page 16-17) .
10. Install the key onto the input shaft (Figure 16-40, Page 16-17) .
11. Position the driven clutch on the transaxle input shaft and install the washer (yellow side facing out) and
mounting bolt. Tighten the mounting bolt to 14 ft-lb (19.0 N·m) (Figure 16-40, Page 16-17) .
12. Install the drive belt. See Drive Belt Installation, Section 17, Page 17-3.
13. Remove the blocks from under the engine and roll the powertrain into position under the vehicle. Then
lift the front of the powertrain and place the snubber into the snubber bracket in the vehicle frame
(Figure 16-41, Page 16-17) .
Figure 16-38 Governor Cable Bracket Figure 16-39 Governor Arm
Figure 16-40 Driven Clutch Figure 16-41 Snubber
KEY
SNUBBER
BRACKET
SNUBBER