Caution:
Refer to
Fastener Caution
in the Preface section.
Support the lower control arm with a hydraulic jack and lift the control arm into the neutral position.
4.
Tighten the front lower control arm bolt (1) to
70 N·m (52 lb ft) +75-90 degrees
, using
EN-45059
kit .
5.
Tighten the rear bushing to frame bolts to
55 N·m (41 lb ft) +45-60 degrees
, using
EN-45059
kit .
6.
Install the NEW ball joint to knuckle bolt and nut and tighten to
30 N·m (22 lb ft) +60-75 degrees
, using
EN-45059
kit .
7.
Lower the vehicle to the ground in order to tighten the control arm fasteners correctly.
Remove the jack stand.
8.
Install the tire and wheel. Refer to
Tire and Wheel Removal and Installation
.
9.
Lower the vehicle.
10.
Front Suspension
SUSPENSION
S e c tion 10
BACK TO CHAPTER INDEX
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
TO MODEL INDEX
