Install the NEW steering gear oil seal to the steering gear.
1.
Ensure the steering gear oil seals are fully seated in the steering gear.
2.
Install power steering gear inlet pipe (2) to vehicle.
3.
Caution:
Refer to
Fastener Caution
in the Preface section.
Install 3 bracket nuts (1) and tighten to
9 N·m (80 lb in)
.
4.
Install inlet pipe (3) to power steering pump.
5.
Install gasket (2).
6.
Install hollow screw (1) and tighten to
21 N·m (16 lb ft)
.
7.
Install inlet hose (3) to clip (2).
8.
Install power steering gear inlet hose bolt (1) and tighten to
11 N·m (98 lb in)
.
9.
Clean any excess power steering fluid from the vehicle and remove the drain pans.
10.
Install front bumper fascia. Refer to
Front Bumper Fascia Replacement
11.
Fill and bleed the power steering system. Refer to
Power Steering System Bleeding
12.
Power Steering
STEERING
S e c tion 09
BACK TO CHAPTER INDEX
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
TO MODEL INDEX
