Heated Seat Components
The driver and passenger heated seats consist of the following components:
• Left heated seat switch
• Right heated seat switch
• HVAC control
• Seat heating control module
• Driver seat cushion heating element
• Driver seat back heating element
• Driver seat cushion temperature sensor
• Passenger seat cushion heating element
• Passenger seat back heating element
• Passenger seat cushion temperature sensor
Power and Ground
Battery positive voltage is supplied at all times to the seat heating control module through a 30 A fuse located in the underhood fuse block.
This voltage is used by the module to supply power to the seat heating elements. Ground for the module is provided at G307.
Heated Seat Operation
The driver and passenger heated seats are controlled by a single seat heating control module that is located under the driver seat cushion.
Both heated seats are controlled by separate heated seat switches that are located in the HVAC control. When a heated seat switch is
pressed, a serial data message is sent from the HVAC control to the HVAC control module indicating the heated seat command. The HVAC
control module then serves as a gateway to transmit the message to the seat heating control module via the serial data line. In response
to this signal, the seat heating control module applies battery positive voltage through the element supply voltage circuit to the
appropriate seat heating elements. The seat heating control module then sends a serial data message back to the HVAC control module to
gateway the information to the HVAC control to either illuminate or turn off the appropriate temperature indicator.
Temperature Regulation
When the engine ON, the heated seats will initialize in the OFF state. With each activation of the heated seat switch, the seat heating
control module will cycle the temperature setting in the following manner: HIGH, MEDIUM, LOW, and OFF.
The seat heating control module monitors the seat temperature through the temperature sensor signal circuit and the temperature sensor
(thermistor) that is located in the seat cushion. The temperature sensor is a variable resistor, it's resistance changes as the temperature of
the seat changes. When the temperature sensor resistance indicates to the seat heating control module that the seat has reached the
desired temperature, the module opens the ground path of the seat heating elements through the heated seat element control circuit. The
module will then cycle the element control circuit open and closed in order to maintain the desired temperature.
Load Management
The electrical power management function is designed to monitor the vehicle electrical load and determine when the battery is potentially
in a high discharge condition. The heated seat system is one of the vehicle loads that is subject to reduction during a battery discharge
condition. For more information on load management refer to
Electrical Power Management Description and Operation.
S e c tion 07
SEATS
Seat Heating and Cooling
BACK TO CHAPTER INDEX
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
TO MODEL INDEX
