Remove the damaged body lock pillar outer panel.
10.
Installation Procedure
Cut the body lock pillar outer panel in corresponding locations to fit the remaining original panel. The sectioning joint should be
trimmed to allow a gap of one-and-one-half-times the metal thickness at the sectioning joint.
1.
Create a 50 mm (2 in) backing plate from the unused portion of the service part.
2.
Create 5 x 18 mm (4/16 x 11/16 in) slots for MIG-brazing along the sectioning cut on the remaining original part. Locate these
holes 13 mm (1/2 in) from the edge of part and spaced 40 mm (1 1/2 in) apart.
3.
Prepare all mating surfaces as necessary.
4.
Fit the backing plates halfway into the sectioning joints, clamp in place and braze to the vehicle.
5.
Align the body lock pillar outer panel.
6.
Create 6 x 20 mm (4/16 x 12/16 in) slots for MIG-brazing in locations where you can not apply a resistance spot welder.
7.
Clean and prepare the attaching surfaces for spot welding and brazing.
8.
Note:
In MIG-brazing areas 50 mm (2 in) must be kept clear of structural adhesive.
Apply structural adhesive to all attaching surfaces.
9.
Collision Repair
BODY REPAIR
S e c tion 03
BACK TO CHAPTER INDEX
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
TO MODEL INDEX
