Callout
Component Name
Preliminary Procedure
Remove the front side door inner panel trim. Refer to
Front Side Door Trim Replacement
.
1
Front Side Door Wiring Harness
Warning:
Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical
loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an
electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these
precautions may result in personal injury and/or damage to the vehicle or its components.
For Vehicles equipped with OnStar® (UE1) with Back Up Battery: The Back Up Battery is a redundant power supply to
allow limited OnStar® functionality in the event of a main vehicle battery power disruption to the VCIM
(OnStar®module). Do not disconnect the main vehicle battery or remove the OnStar® fuse with the ignition key in any
position other than OFF. Retained accessory power (RAP) should be allowed to time out or be disabled (simply opening the
driver door should disable RAP) before disconnecting power. Disconnecting power to the OnStar® module in any way
while the ignition is On or with RAP activated may cause activation of the OnStar® Back-Up Battery (BUB) system and
will discharge and permanently damage the back-up battery. Once the Back-Up Battery is activated it will stay on until it
has completely discharged. The BUB is not rechargeable and once activated the BUB must be replaced.
Procedure
Disconnect the battery.
1.
Remove the water deflector.
2.
Disconnect electrical connectors as needed.
3.
Bolted Exterior Body Panels and Closures
BODY REPAIR
S e c tion 03
BACK TO CHAPTER INDEX
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
TO MODEL INDEX
