If the carpet or the pad or insulator is wet, use the following criteria for drying or for replacing the components:
• For a 1-piece carpet assembly bonded to a cotton or a fiber padding, replace the entire assembly.
• For a 2-piece carpet assembly with a cotton or a fiber padding, replace the padding only. While the carpet is out of the vehicle, dry
the carpet using the method described below.
• For a 1-piece carpet assembly bonded to a foam padding or attached to a synthetic padding, dry the carpet using the method
described below.
• For a 2-piece carpet assembly with a synthetic padding, dry the assembly using the method described below.
Drying Method
If you observe puddles of liquid on the carpet face, use a wet vacuum to remove the excess moisture.
1.
Blot the face of the carpet with a towel in order to absorb as much moisture as possible.
2.
Point a fan at the affected area and air dry the carpet.
3.
Floor Coverings and Headlinings
BODY HARDWARE AND TRIM
S e c t i on 02
BACK TO CHAPTER INDEX
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
TO MODEL INDEX
