Install the front transmission mount bolt (1) and tighten to
58 N·m (43 lb ft)
.
6.
Install the rear transmission mount bracket bolt (2) and tighten to
100 N·m (74 lb ft)
.
7.
Replace the O-rings of the inlet and outlet hoses. Lubricate O-rings with a small amount of hydraulic oil.
8.
Install the inlet and outlet hose (2) to the steering gear (3) and install the power steering gear inlet and outlet hose bolt (1). Tighten
the power steering inlet and outlet hose bolt to
11 N·m (98 lb in)
.
9.
Install the stabilizer shaft link to the strut.
10.
Install the NEW stabilizer shaft link nut (1) and tighten to
65 N·m (48 lb ft)
.
11.
Install the steering linkage inner tie rod. Refer to
Steering Linkage Inner Tie Rod Replacement
.
12.
Install the front compartment insulator, if equipped. Refer to
Front Compartment Insulator Replacement
.
13.
Install the front compartment splash shield. Refer to
Front Compartment Splash Shield Replacement
.
14.
Install the exhaust flexible pipe. Refer to
Exhaust Flexible Pipe Replacement
.
15.
Install the front tire and wheel assemblies. Refer to
Tire and Wheel Removal and Installation
.
16.
Lower the vehicle.
17.
Power Steering
STEERING
S e c tion 09
BACK TO CHAPTER INDEX
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
TO MODEL INDEX
