Callout
Component Name
1
Rear Compartment Lid Emblem Assembly
Caution:
Refer to
Exterior Trim Emblem Removal Caution
in the Preface section.
Procedure
The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for
one hour after assembly to allow adhesive to develop sufficient bond strength.
1.
Use a Heat Gun or equivalent to remove the old nameplate. Clean all adhesive from the rear compartment panel
and wipe the surface dry with a clean lint-free towel prior to installing the new nameplate.
2.
When removing protective liners from the adhesive tape, be careful not to touch tape with hands and do not allow
tape to come in contact with dirt or any foreign matter prior to adhesion.
3.
Close the rear compartment lid prior to adhesion.
4.
Using the palm of the hand, wet out the emblem to the rear compartment lid to ensure full adhesion of the emblem
is made.
5.
BODY HARDWARE AND TRIM
Section 02
Exterior Trim
BACK TO CHAPTER INDEX
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
TO MODEL INDEX
