Special Tools
EN-45059
Torque Angle Sensor Kit
For equivalent regional tools, refer to
Special Tools
.
Removal Procedure
Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle
.
1.
Remove the tire and wheel. Refer to
Tire and Wheel Removal and Installation
.
2.
Note:
DO NOT re-use the lower control arm bolts and nuts. Discard and use NEW only.
Remove wheel speed sensor wiring harness from control arm and steering knuckle.
3.
Remove and DISCARD the lower ball joint to knuckle nut and bolt (1).
4.
Separate the lower control arm from the knuckle.
5.
Remove and DISCARD the front lower control arm nut and bolt (1).
6.
Remove and DISCARD the rear lower control arm bushing nuts and bolts (1).
7.
Front Suspension
SUSPENSION
S e c tion 10
BACK TO CHAPTER INDEX
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
TO MODEL INDEX
