Canon imagePROGRAF iPF8400S, User Manual

Page: 174 / 1004

A
Drying Time
Specify the time that the printer waits for ink to dry, as needed. The Between Pages setting is only valid for rolls.
• B
Between Pages
You can set the time to wait after printing 1 document page until ejecting the paper. Since waiting time is required
for ink to dry before a roll is cut, you can deliver paper in the Output Stacker with the ink dried even if
Cutting
Mode is set to Automatic .
Setting Item Details
Printer Default The setting of the control panel of the printer is applied.
Off Paper is ejected immediately after printing completes.
30 sec. / 1 min. / 3 min. / 5 min. / 10
min. / 30 min. / 60 min.
Paper is ejected when the set time elapses after printing completes.
• C
Between Scans
You can set the time to wait after printing 1 line on a page until printing the next line. Set this to avoid bleeding or
color unevenness such as when bleeding occurs on a page or when color unevenness occurs during borderless
printing.
Setting Item Details
Printer Default The setting of the control panel of the printer is applied.
Off The next line is printed immediately after a line is printed.
1 sec. / 3 sec. / 5 sec. / 7 sec. / 9 sec. The next line is printed when the set time elapses after a line is printed.
* Increase the time according to the occurrence condition of bleeding or unevenness.
D
Roll Paper Margin for Safety
You can specify the length of a margin on the leading edge of paper to ensure that paper susceptible to curling is held
firmly against the Platen.
• E
Near End Margin
Specify the length of the Near End Margin (the leading edge margin) of the roll, as needed.
Setting Item Details
Printer Default The setting of the control panel of the printer is applied.
5 mm (0.2 in) The document is printed in the standard size.
* Select this when you do not have any problems in printing.
20 mm (0.8 in) Select this when rubbing against the printhead occurs such as when using paper that tends to
curl.
F
Cut Speed
Select the speed of automatic cutting, as needed. You can adjust this setting if paper is not cut well when automatic
cutting is used.
Setting Item Details
Printer Default The setting of the control panel of the printer is applied.
High Speed When the Standard setting does not result in cutting the surface cleanly, select this.
Standard Select this when you do not have any problems in automatic cutting.
Low Speed This helps prevent adhesive from sticking to the cutter and keeps the cutter sharp if you select it
when using adhesive paper.
Paper Detailed Settings Dialog Box
iPF8400S
User's Guide
Windows Software
Printer Driver
174