Buffalo Tech TeraStation 5000, User Manual

Page: 177 / 181

177
Recovery I41
PushFuncToStart
Pressing the function button on the
front will start the recovery process.
-
Recovery I42
Preparing
Preparing to start the recovery
process.
-
Recovery I43
Unsupported HW
The TeraStation was started from the
USB recovery device, but the system
cannot be recovered from this USB
recovery device.
-
Recovery I44
Disk1 not found
Recovery from the USB recovery
device was initiated, but the drive 1
was not detected.
Make sure that Disk 1 is present and fully inserted in
its slot.
Recovery I45
Recovery Failed
Recovery failed. -
RAID ARRAY I46
RMM+Processing
Data migration or conversion (RAID
migration) is in progress.
Do not turn off the TeraStation power.
SYSTEM I47
Don’t Power Off
FailOver I48
PushFuncToStart
This TeraStation is ready to become
the failover backup for the main
TeraStation.
Hold down the function button on the front of the
target TeraStation until it stops beeping to accept
failover backup status.
FailOver I49
LostMainTarget
The main TeraStation in the failover
configuration cannot be found.
Make sure that the main TeraStation is on, working,
and connected to the network.
FailOver I50
Maintenance mode
Failover maintenance is in progress. Do not turn off the TeraStation power.
FailOver I51
Initializing
Initializing the failover configuration. Do not turn off the TeraStation power.
New Firmware I52
Available
A new firmware version has been
released.
Update the firmware.
BackupTask xx I54
Backup Failure
xxth backup task failed.
Make sure that the xxth backup task is configured
correctly. Make sure that the NAS is not in standby
mode. If the backup task still fails, check the
network, backup source, and backup destination.
Recovery I55
RecoveryAuthFail
Authentication during recovery of
settings failed.
Settings can only be restored for the TeraStation
whose settings were originally saved. To restore
settings, insert the USB memory device, move the
Boot Mode switch on the rear of the TeraStation
to the USB position, and restart the TeraStation.
Or, settings can be restored in Settings with the
TeraStation powered on.
Surveillance I56
Lack of License
There are not enough surveillance
camera server licenses.
Purchase and register an additional license.
Surveillance I57
No free space
There is not enough space to save
additional surveillance video.
Delete or move some of the stored video.
Surveillance I58
Recording Failure
Video not recorded.
Check your settings. Also, use the utilities provided
with your camera to check that the camera is
operating correctly.