11
TS5200D
TS5400R
1
Power Button
To power on, connect the power cable and wait for 10 seconds, then press the power button. To power off, press
the power button twice.
2
Info LED
If there is a status message, the amber info LED will light up. Check the LCD panel to see the status message.
3
Error LED
If there is an error, the red error LED will light up. Check the LCD panel to see the error message.
4
LAN1 LED
When LAN port 1 is connected, this LED glows green. It blinks when the connection is active.
5
LAN2 LED
When LAN port 2 is connected, this LED glows green. It blinks when the connection is active.
6
LCD Panel
This display shows the status of many TeraStation settings. It also displays errors and messages when available.
7
Display Button
Switches between the different display modes. Also, if the TeraStation is beeping, press this button to stop it.
8
Function Button
Use this button for Direct Copy, dismounting USB devices, rebuilding RAID arrays, and configuring failover.
9
Drive Lock
Open the front panel with the key to replace hard drives or access the reset button.
Summary of Contents for TeraStation 5000
Page 1: ...TeraStation 5000 User Manual www buffalotech com 35020018 04 2014 01...
Page 10: ...10 Chapter 1 Installation Diagrams TS5800D TS5600D TS5400D...
Page 69: ...69 4 Insert the new drive in the empty slot Slide the drive in with the locking mechanism open...
Page 70: ...70 5 Swing the lock back down until it clicks into place...
