BRINKMANN PUMPS Bplogic, Operating Manual, Page: 178 / 291

5 Operating the pump controller
178 bplogic intelligent pump controller 18/02/2021

Many of the settings are pre-configured by the manufac-
turer.

Check that the settings are correct before commissioning for
the first time.

If there are problems with the configuration, contact cus-
tomer service:

When doing so, provide the current configuration file

Section 7.2.1
“Backup and restore
preparation
”
on
page 249 .
Or:

Have the pump controller’s order number and serial
number at hand.
 “Customer service”
on page 8
5.6.1.3 Setting sensor parameters
Parameters are set in the same way for all sensors.
Prerequisite:
The sensors are connected properly

Section 4.3
“Connecting the pump con-
troller electrically
” on page
42.
Also see the documentation for the sensors that are to be con-
nected.

Proceed as follows depending on the sensor used:

Check the configuration for sensors with a digital connection

Section 5.6.1.1
“
Setting parameters for digital inputs and outputs
”
on
page 169 .

For sensors with an analog connection:

Enter the signal form (current/voltage), sensor process values and sig-
nal values (4
mA - 20 mA / 0 V - 10 V).

Check the remaining configuration.

Section 5.6.1.2
“Setting parameters for analog inputs and outputs”
on page 172