BRINKMANN PUMPS Bplogic, Operating Manual, Page: 172 / 291

5 Operating the pump controller
172 bplogic intelligent pump controller 18/02/2021

Many of the settings are pre-configured by the manufac-
turer.

Check that the settings are correct before commissioning for
the first time.

If there are problems with the configuration, contact cus-
tomer service:

When doing so, provide the current configuration file

Section 7.2.1
“Backup and restore
preparation
”
on
page 249 .
Or:

Have the pump controller’s order number and serial
number at hand.
 “Customer service”
on page 8
5.6.1.2 Setting parameters for analog inputs and out-
puts
A designation and a name for the connection point can be assigned to each analog
input and analog output. Furthermore, you can switch the operating mode for the
analog input or output between current mode and voltage mode.
All other settings for the analog inputs and outputs are specified by the manufac-
turer and must be checked before commissioning.
1. In
“Configuration”,
tap
“I/O configuration”
.
 “Configuration – I/O configuration”
(Fig. 96) opens.
2. In
“I/O configuration”,
tap the required I/O module or the required frequency
converter, e.g.
“
I/O module 1
”
.
 “Configuration – I/O configuration – I/O module 1”
(Fig. 101) opens.