5 Operating the pump controller
18/02/2021
bplogic intelligent pump controller
55
An ethernet connection or a WLAN connection is required for remote access. In
order to use remote access, you must call the pump controller’s login screen using
a web browser. To do this, you must open a web address according to the following
template:
http://xxx.xxx.xxx.xxx:8080/web.htm
http://xxx.xxx.xxx.xxx:8080/webvisu.htm
When you open
one of the web addresses, you must replace “xxx.xxx.xxx.xxx” with
the IP address of your pump controller.
Example:
If your pump controller has the IP address “192.168.1.100”, you must open the web
address “192.168.1.100:8080/web.htm” or “192.168.1.100:8080/webvisu.htm”.
Configuring the network settings
The pump controller’s network settings including the IP address
are pre-configured by the manufacturer according to your speci-
fications. You can change the network settings at any time after
initial commissioning.
Section
on page
Section
Setting WLAN module parameters
on
The web address ending in “web.htm” is intended for remote access using a device
with a keyboard, e.g. a laptop or a desktop PC. If you access the pump controller
via the
web address ending in “web.htm”, you can use the keyboard to type values
into the input fields in the pump controller’s software.
The web address ending in “webvisu.htm” is intended for remote access using a
device without a keyboard, e.g. a tablet. If you access the pump controller via the
web address ending in “webvisu”, an on-screen keyboard opens as soon as you tap
an input field.
1.
Turn on the pump controller.
2.
Use a web browser to call the pump controller’s web address.
The login screen is displayed.