5 Operating the pump controller
176
bplogic intelligent pump controller
18/02/2021
translate the electronic signals back into physical process sizes (example:
on page
177). The values to be set for these parameters are available
on the data sheet for the sensor or actuator that is connected.
5.
Set the minimum and maximum values for the process value for the sensor or
actuator that is connected. To do this, take the required values from the data
sheet for the sensor or actuator.
6.
Set the minimum and maximum values for the signal value for the sensor or
actuator that is connected. To do this, take the required values from the data
sheet for the sensor.
7.
Make all other required settings.
8.
Check all settings for which parameters cannot be set.
Analog input