COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
823
Settings – Functions
Automatic Receptions
Waiting time between the announcements or until transfer to the
default destination
Specifies how long the PBX waits (in seconds) for a valid input between and
after the announcements.
Reaction if the destination is busy/does not reply
If the caller enters a valid suffix dialling digit, the destination subscriber is
notified that a call is present.
If the call is not answered within 2 minutes for internal calls and 8 minutes
for external calls, the announcement if the destination is busy/does not reply
is played.
If the destination number is busy, the call waiting function is enabled if this
function is enabled for the destination subscriber. If the destination
subscriber rejects call waiting, or if they have not enabled this function, the
announcement if the destination is busy/does not reply is played.
The system then reacts in accordance with the setting made here.
End of the call
: Three short busy signals are played and the PBX ends the
existing call with the caller.
Call default destination
: The PBX transfers the existing call to the default
destination number entered below. If the call is not answered there either,
within 2 or 8 minutes, three short busy signals are played and the PBX ends
the existing call with the caller.
Note:
If the destination number and the default destination number are
identical, the PBX cuts off the call without calling again.
