778
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Settings – Devices
Relays (Actuators)
Hold time
If switching off is not to be controlled by the PBx (for some relays, e. g. the
a/b Switching Modules, switching off cannot be controlled), the hold time of
the relay can be used instead of the switching duration. This will only make
sense if the hold time of the relay is sufficiently long, for example for a door
opener.
The PBX needs to know how long the relay will be held in order to signalise
holding of the relay on the system phones (see the manual of the device in
question).
Requirements:
•
Created relay
•
Off control switched on for the relay
Enter the hold time of the relay in milliseconds. Possible entries: 10 to 10000
ms.
Relay can be triggered by Action URL
Provided that the access authorisation to Action URLs is granted
system-wide or for a subscriber, the individual manual relay can be triggered
by Action URLs.