COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
261
Phoning
Unsuccessful Outgoing Calls
Initiating Internal Callback on No Response
If the subscriber being called does not pick up the receiver, you can
configure callback on no response in order to reach this subscriber without
having to call him repeatedly.
If you have initiated a callback, as soon as the other subscriber has hung up
the receiver to end the call, the PBX calls you. If you then pick up the
receiver, the other subscriber will be called. If the other subscriber picks up
the receiver, the connection for the call will be established. This deletes the
callback procedure in the PBX.
Important
:
On the system phones, this function is called via the menu/phone app
(optional, see manual for the phone).
To use this function at ISDN phones or to delete it again, this function
must be supported via a function key or via the menu by the respective
phone (optional, see manual for the phone).
Note:
You can also use this function on analogue phones, where it can
be performed via the T-Net function key/menu (optional, see manual for
the phone).
If no one answers on the connection you are calling, proceed as follows:
1. Press the
Flash key
or the
Query key
.
2. Dial
*37#
.
You will hear the confirmation tone.
3. Hang up the receiver.
