744
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Settings – Devices
Door Terminals
Requirements:
•
Relay/actuator (optional, see chapter Technical Data in the Instructions)
•
Created door terminal
A relay with the operating mode
Speaking
,
Door opener
or
Light
is
assigned to the door terminal.
A relay used for this purpose can, for example, be part of a connected door
terminal or be connected to the same port (a/b Switching Module). Alterna-
tively, it is also possible to use a relay for the door function which is part of
another connected device (e. g. an IP switch relay). In this case it must first
be created in the configuration of the PBX as part of this other device and
then be assigned to the door terminal. It then remains part of this other
device in the configuration of the PBX, but takes over the selected door
function for the door terminal.
If suitable relays have already been configured on the page
Devices >
Relays (Actuators)
, a list field will appear now. Select one of the existing
relays and click
.
If you do not want to use any of the existing relays, select
New relays
in the
list field (
cancels the operation). Enter a freely selectable name for the
relay and click
Ok
.
Note:
Alternatively, you can also create and assign relays on the page
Devices > Relays (Actuators)
.
For a detailed description of the operating modes, refer to the chapter
Functions, Uses, Concepts > Relays (Actuators) > Relay Operating
Modes.
