Altigen MAX Communication Server ACC 6.5, Administration Manual

Page: 396 / 488

Chapter 27: System Report Management
382
MAXCS ACC 6.5 Administration Manual
Configure the parameters:
•
Check Enable sending SNMP traps .
•
Enter the SNMPv3 server address.
•
Enter the SNMPv3 server port.
•
Select a security level:
•
No Authentication and No Privacy
•
With Authentication but No Privacy
•
With Authentication and Privacy
•
Select an Authentication Method, and enter a password
•
Select a Privacy Protocol, and enter a password.
•
Configure traps:
•
Memory usage exceeds This trap is sent when MAXCS detects that the lowest
virtual memory usage exceeds a specified percentage of physical memory
configuration within a 10-minute duration. Default value is 80%. The next trap
will be sent after the condition is cleared then occurs again. The minimum
duration between any two consecutive traps is 30 minutes
•
Average CPU utilization exceeds This trap is sent when MAXCS detects its
average CPU utilization exceeds a specified percentage in any 10-minute
duration. Default value is 80%. The next trap will be sent after the condition is
cleared then occurs again. The minimum duration between any two consecutive
traps is 30 minutes