Altigen MAX Communication Server ACC 6.5, Administration Manual

Page: 162 / 488

Chapter 11: Board Configuration
148
MAXCS ACC 6.5 Administration Manual
Configuring the MAX1000/2000 Board
The MAX1000/2000 Server is a telecom appliance that consists of an embedded DSP
board and two access board slots. MAXCS treats the entire MAX system as one board
with two access board options. The Boards window displays the name of the MAX board,
followed by [xxyy(-T1),xxyy]:
Figure 19. Boards View showing MAX board
xx
refers to the number of analog trunks, and
yy
refers to the number of analog
extensions. If an access board has a T1/E1 port,
-T1
is added to the end.
In the Boards window, double-click the MAX 1000/2000 board to open the main Board
Configuration window:
Figure 20. Board Configuration window
The Channel Group Info panel shows the channel groups (groups of channels that
belong to the same type). For example, if one 4x4xT1 access board and one 4x8 access
board are installed in the MAX main board, there will be three channel groups for the
4x4xT1 card, and two channel groups for the 4x8. When one of the channel groups is
selected, the
Channel Mapping List reflects the selection.
•
Double-clicking a T1/E1 channel group opens the channel group configuration dialog
box. For information on configuring in this dialog box, see “T1 and E1 Configuration”
on page 127. This is available on T1 or E1 channel groups only.
•
In the channel group configuration dialog box, click the Protocol button to open the
Protocol Configuration dialog box. For information on configuring protocol, see
“Setting up Channels on the Triton T1/E1 Board” on page 131.
Double-clicking a channel in the Channel Mapping List opens the appropriate
configuration dialog box for that channel.