Agilent Technologies 4294A, Operating Manual

Page: 459 / 469

Appendix D 451
Initial Settings
Initial Settings, Settings that can be Saved/Recalled, Settings that can be
Backed Up
D. Ini
tia
l S
etti
ngs
Fixture
compensation On/Off Open Off
¬ ¬ Ö
Short Off ¬ ¬ Ö
Load Off
¬ ¬ Ö
Standard definition
for data measurement Open G 0 S ¬ ¬ Ö
C 0 F
¬ ¬ Ö
Short R 0 W ¬ ¬ Ö
L 0 H
¬ ¬ Ö
Load R 50 W ¬ ¬ Ö
L 0 H
¬ ¬ Ö
Data measurement point setting for user calibration and
fixture compensation
Fixed
¬ ¬ Ö
Fixture compensation coefficient Empty
¬ ¬ Ö
Trigger Sweep mode Continuous ¬ Hold Ö
Trigger source selection Internal (Free run)
¬ ¬ Ö
Polarity of external trigger signal Positive ¬ ¬ Ö
Trigger event mode On sweep
¬ ¬ Ö
Marker Marker (main marker) Off ¬ ¬ Ö
Sub marker Off
¬ ¬ Ö
Objective trace selection (Data/Memory) Data ¬ ¬ Ö
Trace A/B coupled mode On/Off On
¬ ¬ Ö
Marker movement mode (Continuous/Discrete) Continuous ¬ ¬ Ö
D
marker mode Off
¬ ¬ Ö
Sweep parameter value Stimulus value ¬ ¬ Ö
Level monitor value display mode Off
¬ ¬ Ö
Marker list display Off ¬ ¬ Ö
Marker search Search function Off
¬ ¬ Ö
Target
search Target value Off ¬ ¬ Ö
Target line display Off
¬ ¬ Ö
Peak
definition D X value 500 kHz ¬ ¬ Ö
D
Y value 1
¬ ¬ Ö
Polarity (Positive/Negative) Positive ¬ ¬ Ö
Search tracking function On/Off Off
¬ ¬ Ö
Partial
search On/Off Off ¬ ¬ Ö
Search range Lower limit value 40 Hz
¬ ¬ Ö
Upper limit value 110 MHz ¬ ¬ Ö
Search
range for
List sweep Full (All segments)/Specified segment Full
¬ ¬ Ö
Search segment 1 ¬ ¬ Ö
Search range line display Off
¬ ¬ Ö
Table D-1 Initial settings, settings that can be saved/recalled, settings that can be backed up
Function Setting
Initial settings
(factory settings)
[Preset] *RST
Save/
Recall
Backup