ABB Relion 670 Series RES670, Technical Manual

Page: 156 / 888

RLdInRv = kLdRRv·RLdOutRv
EQUATION1187 V2 EN
(Equation 6)
where:
kLdRRv is a settable multiplication factor less than 1
From the setting parameter RLdOutRv and the calculated value RLdInRv, a distance
between the inner and outer boundary,
D
Rv, is calculated. This value is valid for R
direction in second and third quadrant and for X direction in third and fourth quadrant.
The inner resistive characteristic in the second quadrant outside the load encroachment
part corresponds to the setting parameter
R1FInRv for the inner boundary. The outer
boundary is internally calculated as the sum of
D
Rv+ R1FInRv.
The inner resistive characteristic in the third quadrant outside the load encroachment zone
consist of the sum of the settings
R1FInRv and the line resistance R1LIn . The angle of the
tilted lines outside the load encroachment is the same as the tilted lines in the first
quadrant. The distance between the inner and outer boundary is the same as for the load
encroachment in reverse direction, that is
D
Rv.
7.1.6.3 Reactive reach in forward and reverse direction
The inner characteristic for the reactive reach in forward direction correspond to the
setting parameter
X1InFw and the outer boundary is defined as X1InFw +
D
Fw,
where:
D
Fw =
RLdOutFw - KLdRFw · RLdOutFw
The inner characteristic for the reactive reach in reverse direction correspond to the setting
parameter
X1InRv for the inner boundary and the outer boundary is defined as X1InRv +
D
Rv.
where:
D
Rv = RLdOutRv - KLdRRv · RLdOutRv
7.1.6.4 Basic detection logic
The operation of the Power swing detection ZMRPSB (68) is only released if the
magnitude of the current is above the setting of the min operating current,
IMinPUPG .
Section 7
1MRK 511 365-UUS A
Impedance protection
150 Phasor measurement unit RES670 2.1 ANSI
Technical manual