ABB Relion 670 Series RES670, Technical Manual

Page: 735 / 888

20.9.3 Signals
Table 604: TESTMODE Input signals
Name Type Default Description
IED_TEST BOOLEAN 0 Activate IED test mode
Table 605: TESTMODE Output signals
Name Type Description
TEST BOOLEAN In test via IED TEST or via LD0 Mode
IED_TEST BOOLEAN IED test mode is active
BLOCK BOOLEAN Active when LD0 is blocked or test blocked
NOEVENT BOOLEAN Event disabled during test mode
INPUT BOOLEAN IED TEST input is active
SETTING BOOLEAN IED test mode setting is On
IEC61850 BOOLEAN Active when LD0 Mode is in Blocked, Test or Test
blocked
20.9.4 Settings
Table 606: TESTMODE Non group settings (basic)
Name Values (Range) Unit Step Default Description
IEDTestMode Disabled
Enabled
- - Disabled Activate IED Test mode
EventDisable Disabled
Enabled
- - Disabled Event disable during test mode
BlockAllFunc Disabled
Enabled
- - Enabled Block all functions when entering IED test
mode
CmdTestEd1 Disabled
Enabled
- - Disabled Require test bit in command at test mode (only
for IEC61850 Ed1)
20.9.5 Operation principle
Set the IED in test mode by
• configuration, activating the input SIGNAL on the function block TESTMODE.
• setting TestMode to Enabled in the local HMI, under Main menu/TEST/IED test
mode .
1MRK 511 365-UUS A
Section 20
Basic IED functions
Phasor measurement unit RES670 2.1 ANSI 729
Technical manual