Operation,
Remote Operation
139187 / Rev. 500
RGS-2000NG TCAS Test Set Operation Manual
1-2-5
September 2021
Subject to Export Control. See Cover Page for details.
Page 37
5.8.7.3.2
Energy Chips
5.8.7.4
Overlapping Parameters
5.8.7.4.1
Pulse Delay
5.8.7.4.2
Pulse Width
5.8.7.5
Preamble Validation Test Parameters
5.8.7.5.1
Delta Amplitude
Command
{:RGS | :RGS2000NG}{:DO260}{:TYPE}{:CONFIDENCE | :CONF }
Syntax:
{:ENERGY}{:CHIPS}SP<numeric>[,<numeric>[,<numeric>[,<numeric>[,<num
eric>]]]]CR
Description:
This command sets the list of Bits with energy on both halves of the chip.
This command allows defining up to five different energy Bits.
Numeric:
1 to 112 if the reference is a long Mode S
1 to 56 if the reference is a short Mode S (decimal ASCII).
Default:
None selection.
Example:
:RGS:DO260:TYPE:CONF:ENERGY:CHIPS 3,7,15,25,44\r
Command Syntax:
{:RGS | :RGS2000NG}{:DO260}{:TYPE}{:OVERLAPPINGPULSE |
:OVERLAP}{:PULSE}{:DELAY}SP<numeric>CR
Description:
This command sets the pulse delay relative to P1.
Numeric:
-20000 to 2000 ns (decimal ASCII)
Default:
0 ns
Example:
:RGS:DO260:TYPE:OVERLAP:PULSE:DELAY 2000\r
Command Syntax:
{:RGS | :RGS2000NG}{:DO260}{:TYPE}{:OVERLAPPINGPULSE |
:OVERLAP}{:PULSE}{:WIDTH | :WID}SP<numeric>CR
Description:
This command sets the overlapping pulse width.
Numeric:
0 to 130000 ns (decimal ASCII).
Default:
0 ns
Example:
:RGS:DO260:TYPE: OVERLAP:PULSE:WIDTH 4500\r
Command Syntax:
{:RGS | :RGS2000NG}{:DO260}{:TYPE}{:PREAMBLEVAL | :PREA
}{:CHIPS}{:DAMP}SP<numeric>CR
Description:
This command sets the delta ampli tude in dB for energy Bits of the pulse.
Numeric:
-10 to 10 dB (decimal ASCII)
Default:
0 db
Example:
:RGS:DO260:TYPE:PREA:CHIPS:DAMP -6\r
